Rock Chucker Deprimer Tray Replacement by harddrv1

Last crawled date: 3 years ago

This Item was originally Posted by Defense distributed before they were made to take there downloads of there site by the US Government (Because they had working gun files) This is however not a working gun file
Original Posters Notes
ROCK CHUCKER DEPRIMER TRAY REPLACEMENT
Description
Cleaned up some interference on the fit and printing. Works for left and right models, PLA or ABS plastic.
The molded plastic “tray” that comes on recent RC with the 1″ ram tend to miss the primers and jam about every 100 rounds, then you spill the rest of them while trying to pull the sucker out of the frame. Attached files for 3D printed version that gets most of them into a 1/2″ plastic tube that goes down to a jug on the floor. Left hand and right hand versions are included.
Files are SCAD and STL format. Print with 3 perimeters, for strength, and enable support in your slicing program. 0.35 mm layer works fine, ABS or PLA. Get the thin vinyl clear tubing from local hardware store. It just pushes on the tapered nozzle.
Replacement for the inverted "Y" tray that is supposed to capture primers removed from cases on RCBS Rock Chucker Supreme.
This snaps into the same area behind the ram, but is retained by a lug in the slot and a ring that goes around the ram. Remove shellholder before installing or removing the tray. Select the version for a hose that goes on either the left side or right side of the frame, then down to a small bottle or plastic jug.
Source files include a"wHS" option "with Heat Shield" to keep the piece flat on the build tray for ABS, especially if your print table is small or slightly cold. The shield pieces can be easily trimmed off after the print cools.
Due to the nozzle, you will need to use support, but it can be 4mm or 5mm spacing. It simply rams out of the tube with a large hex key. Avoid using a flat-blade screwdriver. Hose is 4 or 5 feet of 1/2" or 13mm ID clear vinyl flex tubing available from local hardware store.
Print anywhere in the 0.25 to 0.35 mm layer height, ABS or PLA, with 0.3 rectilinear fill, at least 3 perimeters and 4 top and bottom layers.