Rift S Latch by BobStuntsville

Last crawled date: 2 years, 11 months ago

I made this little thingy that you put on the ring on your rift s or quest controller. this is supposed to replicate the back hand grip that's on the index knuckles. i am new to 3d printing, so if i did something super terrible with this model im sorry
this works for the rift s and the quest 1, since they use the same controller. i have not tried this on the quest 2 cause i dont have one
Printing:
no way this takes no supports at all!! woo. aint that great. i recommend printing with something like 20-30% infill and try to get the infill lines to line up with the model itself. i think i had something like three or four wall line density, it was probably four. i tried em for a little bit and they work pretty well for what i designed em for.
Assembly:
use the strap for the controller and wrap it in a small rubber band and position it on the teeth of the model. once it is connected and will not move easily, clip the model onto the ring of the controller by resting the top part on the top of the ring and sliding the bottom lip underneath the ring, clipping it into place. you can move the rubber band up and down the teeth for adjustment.