Resin Version of sickofyou's COMBINER WARS Defensor Foot

Last crawled date: 4 years, 3 months ago

I printed these on my Elegoo Mars resin printer. I figured since I already did all the prep work I might as well share the .stl.
I had hollowed it out in Chitubox to make the walls 3mm to save some resin. And while I made tiny holes to avoid suction issues I did not add drainage holes. I used the Elegoo Translucent normal resin so I could see the resin floating around inside the hollow areas. So I had to drill into the bottom of the foot to drain out the extra goo. I then went back and added holes to the bottom of the feet for drainage. I also decided to add a small drainage hole on the socket as well for good measure.
The joint base needed just a little sanding and it slid in from the bottom nice and snug at the top. I also used the 17.5 ball but the 18 is in the .stl I submitted because I found 175 a little loose and I had to take a couple of drops of super glue and use the ball to put a thin coat on each and pop the ball out before it set.
I used medium supports so I included a no_support version as well.
As resins differ, your mileage may very But they work great for me.
I plugged the original "feet" into the back of Silverbolt's hands and used them as mounts for Air Raid and Skydive's weapons for extra storage but more importantly, extra firepower! (See 3rd picture)
And of course a glamour shot to show how he stacks up to the rest of the gang. (See 4th picture.)
Many thanks to the designer.