Thingiverse
Red Bull Cap - 8.4oz & 12oz by malebox
by Thingiverse
Last crawled date: 4 years, 2 months ago
I've got a bad habit of knocking over my Red Bull cans while at work, plus I'm tired of having to check to see if any bugs flew into my drink before sipping.
I printed this in TPU to make sure it'd slide over the lip and stay on in case of a tip. You can try other filaments, but you may have to scale it up, and I'm not sure even then how well it'll handle.
Note: the original test prints I did with SainSmart TPU (green), but tried some unknown name brand (red/black) for a two-tone print. The supports on the first were easy to remove, the black one, not so much. I got most of it cleared, though, and it still works. So, if you can put your own supports in (such as with Simplify3D), I'd recommend it.
Edit: Finally scaled one up for the 12oz Red Bull can as well. The green one is the 8.4oz, and the blue is the 12oz version.
Cheers!
I printed this in TPU to make sure it'd slide over the lip and stay on in case of a tip. You can try other filaments, but you may have to scale it up, and I'm not sure even then how well it'll handle.
Note: the original test prints I did with SainSmart TPU (green), but tried some unknown name brand (red/black) for a two-tone print. The supports on the first were easy to remove, the black one, not so much. I got most of it cleared, though, and it still works. So, if you can put your own supports in (such as with Simplify3D), I'd recommend it.
Edit: Finally scaled one up for the 12oz Red Bull can as well. The green one is the 8.4oz, and the blue is the 12oz version.
Cheers!