receipt paper shopping list by mer2329

Last crawled date: 3 years, 1 month ago

although this is not a remix as it is a from scratch creation
i did mark it as a remix because it is fully inspired inspired by https://www.thingiverse.com/thing:2786713.
this will add many improvements over the original thing,the improvements include the following
15x4 disc magnets, neodymium magnets work best.
separate pen holder
more clearance in paper arm
a m8 nut on the arm to stop the roll from falling off.
to assemble you will need the following:
glue: must stick to your material, i used e6000 and printed in PLA. i have also used original gorilla glue (the amber, foaming one)
m8 plain nut, or m8 flange nut (smooth, or non serrated flange), or m8 thumb screw.
6x 15x4 disc magnets, neodymium magnets work best
you could probably get away with 5 of them, if you use only one in the pen holder
recommended extras.
a half page address label. as a better writing surface
if using a plain nut or some thumb screws then i also recommend a m8 flat washer or fender washer,
sand paper
these are the maganets i am using