Raspberry Pi NoIR Night Camera Case & Ball joint Stand by IamSLy

Last crawled date: 3 years ago

Accessory for the Raspberry Pi NoIR Night vision camera:
Slim Case with open back for good cooling
Ball Joint allowing 40deg deflection in X and Y and 360deg in Z.
Small stand
Attach compatible with my Articulated Arms Build System https://www.thingiverse.com/thing:4755994
Cleaning & Mounting instructions:
If the screw of the base does not easily go in the nut, do not use force:
Engage the nut
Exert rapid twisting motion in both directions so that the screw goes progressively more in
From time to time, remove the screw and clean the thread before trying further.

Make sure the ball has no blobs
Place the ball in the nut and screw the base on it
Glue the ball strut in the ball with the ball inside the nut
Print instructions:
Print orientation as on the picture tagged "easy print"
No support required
Max 0.4mm line width
Dimensions are exact without any clearance*
(*) This allows for a really nice and tight fit adapted to your own print settings:
Just make sure you have your "Horizontal Expansion" setting calibrated.
As a reference, I used -0.18mm for PETG at 0.16mm layer height.