Raspberry Pi Camera V2 Snapmaker 2 Toolhead Mount by nivekmai

Last crawled date: 3 years ago

A mount to attach your raspberry pi v2 camera to the toolhead of your Snapmaker.
This allows you to aim the camera directly at the extruder nozzle so you can closely inspect layers as they go down to ensure no problems.
Mounting hardware (All came in this kit):
To replace the toolhead screws
4 M2x6

For the toolhead mount <> horizontal arm
1 M2x10 screw
1 M2 nut

For the horizontal arm <> sliding mount
2 M2x8 screws
2 M2 nuts
2 M2 washers

For the sliding arm <> vertical arm
1 M2x14 screws

For vertical arm <> pi camera v2
4 (or 2 if you're lazy) M2x4 screws
You might wants nuts too (again, if you're not lazy)

NOTE: I messed up a bit on the dimensions, so the vertical arm must attach to the toolhead mount one rung "up" from where it was originally designed. I moved the object up in the f3z file though so you can see what to do. If you mount it in the original designed location, the camera will probably run into your prints if it's able to see the extruder nozzle. (all the shots below have it in the right position though)