PrintrBase - ATX Power Supply Base for PrintrBot Simple Metal by tedkeys

Last crawled date: 3 years ago

Two part case to hold an ATX power supply for a PrintrBot Simple Metal with Heated Bed.
This can be printed by the PrintrBot Simple Metal - each piece just barely fits in the 150x150x150 build envelope.
I had to modify my ATX power supply case so that the wires exited the ATX case from the end rather than the side opposite the power connector, since there is not much room between the wall of the case and the back of the ATX supply.
A ridge on the top of the base keeps the PrintrBot from sliding off. Ultimately, I ran some large tie-wraps through the vent holes and over the PrintrBot base to hold the PrintrBase and PrintrBot together.
The front of the PrintrBot hangs over the end of the PrintrBase a bit. This is intentional so that the reset button can be accessed.
The hole in the front is to accommodate a power switch, although my ATX supply did not have one.
Edit: This version fits the rather small power supply that I was using at one time. Larger supplies can be accommodated by my 4-piece version, thing #684427