OW+/XR Concave footpad by MorningMist

Last crawled date: 3 years, 4 months ago

Onewheel plus/XR concave rear footpad.
Features:
A mellow concave that runs all the way to the fender (sorry FlightFins users): the whole surface is there for you to enjoy.
Comfortable heel-to-toe concave provides control without messing with your fakie riding.
A pronounced front-to-rear concave ending with a small leap to lock your foot in place without any disgraceful height.
Insert-less design: uses embedded stainless-steel nuts instead, both cheaper and stronger.
Recessed front screws allow for reusing original screws. You can even grip over the front screw holes if you install it on your board first.
A channel to evacuate sideways, rather than on your grip, any water dripping off the fender.
Rounded front corners to prevent lifting off the bed during printing.
You will need two standard stainless-steel nuts (either M5 or #10-32, pick the corresponding STL) that will be embedded during print, as well as two slightly longer screws than the originals: contrary to inserts (thread starts at the surface), embedded nut threads start deeper in the pad.
Re-use the two original front screws.