Organizer for electronic components - Arduino parts

Last crawled date: 4 years, 1 month ago

These are svg cut files for a tabbed box which is tabbed throughout, needing no glue whatsoever inside as all pieces inside are friction and size fit. I did use some small drops of superglue on the outside pieces just to be sure that it stays together through handling. Designed this for holding the small component pieces that are used with Arduino type electronics. Constructed out of 1/4" MDF (this is actually important, as the tab depth is the relevant to the fit).
Note - There are two separate files in order to fit on a laser with a bed of 24"x12" - you need the pieces cut out from BOTH of the files to make a single box.
Note - The size of this box initially seems deep for the small components, but the divisions need to be this deep to hold the tallest Arduino components like a joystick - see picture. The height gives just enough clearance for these components.
Note - I had some issues cutting clean though with the laser in a few areas, this is why there are chips - from the board pulling apart when I separated the pieces.