O11

...c701 o11 feet by uno132 thingiverse elo

...case - prototype uwu by uno132 thingiverse just my design of a insta360 go camera mount for the diatone tinawhoop. super simple.

...#39;s not finished yet. the first print (picture above) looks good. one foot on the bottom is wrong placed and needs to be fixed.

... ziam thingiverse when you use aio cooler, you can use it. i place in-take fan for vrm cooling. 8x silicone fan rivet 120mm fan

...io shield to do the same thing. it's made for an o11 dynamic, but the size is fairly standard and should really fit any case.

...yourself if needed. there is no room for the dust-filter on the inside as i wanted more flow. adjust height for that if you want.

...lready very minimal) cables from the uni fan setup. should be enough clearance but haven't tested with many motherboards yet.

...mount for the pc case, but i don't run a top fan on my pc, so i remixed it to move the mounting holes to the top of the print

... for the lightstrip. print the 2 big things upside down, it works fine without the supports and you get a nice finish at the top.