NERF Vulcan Tripod Magazine Mount by cuboid10824

Last crawled date: 3 years ago

Do you need a simple, easy to use system to use almost any mag-fed NERF blaster with a Vulcan tripod? If so, this is the 3D print for you!
This is a magazine stand for a Nerf Vulcan tripod. Intended to allow placement of a blaster on the tripod with ease, this tripod stand opts to use the magazine, boasting a more central position, to hold the blaster. This means that the blaster is more evenly weighted front / rear across the tripod, increasing ease of use.
Currently, the magwell is a little tight. This means that using it as an easy on/off emplacement is difficult. I plan to upload a second model, with looser tolerances, to allow for use more as an emplacement. This second model will also include a drain hole, allowing use in more permanent outdoor wars (lookin' at you, Thunderdome).
Works with 12 dart clips. Should work with 18 dart clips, but is untested. Will work with a 6 dart clip, but the grip on the magazine is not that good. (who would have a gun emplacement with only 6 darts anyway)
Will NOT work with the 10 dart curved "banana" clips, and (obviously) any "drum" style magazines.
I do not run an Etsy or anything of the sort, but I could care less if you have it printed on MakeXYZ or perhaps 3dHubs. Just don't buy it from any of those drop-shipping eBay sellers.