MPSM V1 Fan Shroud Remix by Netfool

Last crawled date: 3 years ago

This is a minor remix of the Fan Shroud Replacement by nBurn and the Shroud Clip by Archisim.
Changes to the Shroud are:
Adding a horizontal stop on the heat sink side to ensure the shroud won't slide low enoungh to interfere with the print.
Modifying the clip ears to work better with Archism's shroud clips.
Strengthening the side walls at the top of the shroud. (I broke an early attempt removing stubborn supports).
The only change to the Shroud Clip is the addition of two holes to accommodate a small tie-wrap to secure the extruder and fan wires if you choose to free your bowden tube from the cable wrap spiral.
I printed mine from PETG. PLA isn't likely to survive this close to the extruder.
UPDATE: I added two new versions:
One has no scoop to cool the print. This works well for PETG and ABS. Not recommended for PLA.
The second is an experiment with a cut-out in the back of the scoop to accommodate a silicone glove around the heater block.