Motherboard Standoff by maxharrison

...tx motherboard standoffs by snagglemaw thingiverse a teeny tiny screwdriver for teeny tiny atx motherboard standoffs. m3 x 0.5mm

...motherboard stand off by sthone thingiverse standoff for a mounting a motherboard to a flat surface.

...otherboard from the ground and avoid any shortage :) used with #6-32 unc screws (typical larger pc screws) modeled into standoff.

...odore 64. cut off old standoffs, sand smooth then attach these standoffs with epoxy. be sure to align with the holes in the case.

...se the nut and bolt version which uses 6 nuts and 6 bolts with m3 threading. i print with very low infill to keep the price down.

...to screw in and out the motherboard standoffs for the cooler master hyper 212 evo. this is my first model uploading to this site!

...ape controller, and sainsmart relay board in my pinball cabinet project: http://lilmikey.com/2017/02/16/virtual-pinball-cabinet/

...of the standoff to 15mm. this made for better airflow. printed off wonderfully and very quickly on my first try! thanks for this.

...t at 99/98% size. at 100% they're a very tight fit. i ran a tap in just a little bit to create some threads for it to follow.

...t to, once it dries you can remove your board and have a perfectly aligned layout. tips are appreciated if this helps you out =)

...pillars/spacers by maxharrison thingiverse i used these to separate two pieces of wood above my motherboard on my computer case.

...hard drive cage by maxharrison thingiverse this is a hard drive cage for 3.5" hard drives.

...motherboard cover by shurikkun thingiverse motherboard cover

...motherboard atx by joselcl98 thingiverse motherboard model atx

...motherboard by gameaddict thingiverse hi! i used 123d catch to get this 3d model. it's an old dell motherboard

...motherboard mounts by dvan thingiverse mounts to mount your motherboard...

...ra motherboard case for original anet 1.0 motherboard. i used m3x8mm screws to attach the door case. enjoy it and show your print

...motherboard atx 1.0 by juanch616 thingiverse motherboard matx 1.0

...flexbot motherboard-cover by inspiration thingiverse motherboard-cover for flexbot

...aorus motherboard logo by danielhc thingiverse logo for the motherboard aorus ryzen

...m3a78 motherboard backplate by evgenru thingiverse back panel for asus m3a78 motherboard

...20x20 standoff thingiverse standoff for 8mm linear rails. standoff distance 20mm

...standoff by charlespax thingiverse this is a standoff created to hold up a friend's monitor.

...standoff holder by jfaller thingiverse holder for for m3x6 standoff.

...odore 64. cut off old standoffs, sand smooth then attach these standoffs with epoxy. be sure to align with the holes in the case.

...bts7960 standoff by albatito thingiverse standoff for bts7960. m3 hardware

...of the quad copter, but without the standoffs and with 3mm holes below where the standoffs were. requested by fb user ian paine.

...standoff capacitor holder thingiverse 25v/35v standoff capacitor holder. fits a 13mm capacitor.

...printbed standoff feet by shawdreamer thingiverse standoffs

...standoff by intijk thingiverse 12 + 4 mm height