Monoprice Wanhao Maker Select i3v2 Spring Cups by Nerys

Last crawled date: 3 years ago

None of the cups on thingiverse fit my springs. not sure if mine are different from the wanhao ones?? they were all too small (by a lot)
so I made my own. I had to print them at 103% (on x and y only leave z at 100%) They NEED to fit LOOSE and not restrict the springs or they will inhibit them from "rising" on fine adjustments. so clean up the inside also if your printer is a little sloppy.
These will keep the springs from "tilting and bending" which will throw off your bed level.
I made them 7.3mm tall which is a little smaller than the spring fully compressed so they won't interfere with the movement or compression of the spring as long as they fit LOOSELY.
both holes are also beveled though you won't really see this unless you print at high resolution.