Modern Toilet Paper Holder

Last crawled date: 4 years, 3 months ago

My wife was tired of the cheap chrome bathroom fixtures that came in our house. This toilet paper roll holder is sturdy and easy to print.
You will need some additional hardware:
2 - 3/8, 2 1/2" bolts
1 - 3/8 steel washer
1 - 3/8 nylock nut
1 - 3/8 neoprene washer
4 - screws and wall anchors of choice (I used m4 x 20mm bolts and these wall anchors).
And some epoxy if you want. See assembly instructions below.
Assembly:

After printing, add a little bit of epoxy into the cavity in the back of the rightTP piece, and insert one 3/8 bolt until flush.


Place the steel washer and other 3/8 bolt through the back of the leftTP piece. You will want this to spin freely, so do not use any epoxy here.


Place the neoprene washer onto the end of the bolt on the front of the leftTP piece.


Add a little bit of epoxy to the opening for the nylock nut on the armTP piece.


Screw armTP onto leftTP until you get the desired tension. You will need an open wrench or socket wrench to hold the back of the bolt in place.

Last, you'll want to mount the pieces on the wall. I recommend mocking up where you want it to go. Once you have this marked, use tape or a pencil to mark where each side will go. It helps to have someone hold the pieces while you check for level.
Good luck with installation. Take your time and it will look great!