Master replicas Yoda Proffieboard Conversion Chassis v1.0 by lerath666

Last crawled date: 2 years, 11 months ago

This is a Chassis for the 2007 Master Replicas Yoda Force FX lightsaber, to convert it to use a Proffieboard V2, and Hold an 18650 Battery.
The Chassis is designed to fit into the hilt, and be held in place by Screws using the existing threaded holes that hold on the Switch section of the Lightsaber.
Speaker is Centrally mounted, and you have Recharge Port and access to the Proffieboard USB and SD cards just by removing the pommel.
Existing switch can be used, I recommend mounting magnets to the existing switch, and to the switches you mount on the chassis.
Update: I realized my screw holes were in the wrong position. They made the switch section angled, and inaccessible. I've moved the holes, and I've also added a switch plunger. I modified my plastic switch section to be longer on mine, so YMMV.
Unfortunately, the print is fragile, so every time I have printed it with supports, it breaks while trying to remove them, So I would not recommend using supports, and just clean the print up with an Xacto afterwards.
The Screws in the Sqitch/Clamp section are threaded for 3-56. I have found that 3-56 X3/8 to be too short to grab properly. So I'm going to try 3-56 x1/2 next.
Granted, you really only need the ONE screw to hold the chassis in place. and replacing the short screw in teh "clamp" ring with one of the stock long ones works just fine.
These are the screws i intend to try next
https://www.mcmaster.com/91253A099/