Mark VII Tricorder (Ready for PropFX electronics) by dinoi

Last crawled date: 3 years, 3 months ago

WARNING: This is a prototype / work in progress. It is not yet fully tested.
I am still tuning these.
This Tricorder was designed to fit the PropEFX electronics kit:https://www.etsy.com/listing/509553333/sale-star-trek-mark-vii-science
Note from the creator:
As with any of my files here; These are offered for free. If you like my work or plan to sell prints of it; I encourage you to donate to my favorite charity
https://creativity.org/support/
These files are best printed with a resin printer. All the files labeled BITS should be printed in transparent resin. Files labeled 2X need to be printed twice.
Additional materials you need:
Magnet for second reed switchhttps://www.amazon.com/gp/product/B07873ZCY4
Magnets for inclosure panelshttps://www.amazon.com/gp/product/B0819JZF66
Hingeshttps://www.ebay.com/itm/6031-3-4-x-3-4-Brass-Plate-Butt-Hinge-10-pcs-FREE-SHIPPING/352634680269
Here's the basic instructions for installing the electronics kit:
put main reed switch in divot
attach hinges to main body... make sure the orientation is correct
solder the positive and negative from main board through holes to hinges
run the front sensor, the speaker, the buttons and the the front lights up through the sensor hood (don't affix them at this time)
bend the red light on the top of main board into power hole
secure main board into all LED holes
secure the buttons into the divot
secure everything else on the main body... do the sensors last.
on the flip shell... solder the positive and negative
Please let me know what issues you encounter.