Make out with Mistletoe by barb_3dprintny

Last crawled date: 3 years ago

Happy Holidays - hope you get lucky under the mistletoe!
There are two versions of leaves as the first one I made used a holly leaf but that is not botanically correct. More information: Kissing under the mistletoe or is it holly?
I designed this on Tinkercad and printed in NinjaFlex. Not sure how it will work out in other filaments (mainly the connector). I added the connector to keep the leaves and berries spaced properly when hanging. The leaves go in the outside holes and the 3 berries go through the same center hole. If you use a harder filament you could probably push into a small piece of Styrofoam for the spacers instead of using the connector.
I printed another one in SemiFlex - not much difference except it fits better in the connector.