MagSafe iPhone and Apple Watch charging stand by GrevTech

Last crawled date: 2 years, 10 months ago

Credit for this design goes to https://www.thingiverse.com/jburd/designs I simply added the cable tracks on the back. I also added an addition file with and extension to support a phone if it isn't magnetic (tested with iPhone 11 and it worked great).
Original link to jburd's design is here: https://www.thingiverse.com/thing:4811627
Rotate the print so it's sitting on it's side. I found it prints with less supports material if the side for the phone is touching the build plate (as seen in the picture).
Printed with 25% infill and 2 wall for most of the print. For the section between the phone and watch I printed at 50% infill and 4 walls for better strength and less chance of cracking the print when removing supports (I found out the hard way).
Sliced in Cura with tree supports.