Magicolor 1600w repair part by Mapleperson

Last crawled date: 3 years, 1 month ago

My Magicolor printer suffered a small fall during a move. The paper support tray on top suffered a broken attach arm. After a few months of printing without the tray I decide I had to fix it. Of course the broken part was long lost by that time. A new one had to be made. This project is the result.
Note I printed the part with the largest flat side down which produced support under the small portion, however I think it can also be printed as is, the part vertical. It is a small part so some experimentation will not be too expensive.
The part is Superglued to the original tray as in the picture.Just clean and lightly sand the surface to get good adhesion.