Lens Cover and Controller Holder for Oculus Go by Chimaera

Last crawled date: 3 years ago

If you would like to order the Oculus Go Lens Cover you can now do so here - https://www.etsy.com/listing/749543956.
Please note that this cover does NOT fit the Oculus Quest or Rift S, however you can buy one that does from our Etsy store - https://www.etsy.com/shop/BaptieWright3D
Please remember that this design is available for private non-commercial use only and that any commercial (for-profit) production of this design or derivatives by anyone other than myself or ogovrgear.com is a violation of copyright law.
Lenses on VR equipment are very sensitive to sunlight, and the Oculus Go headset does not come with a cover or case so I designed a fitted protector for the lenses and also incorporated a holder for the controller. Designed in 2 pieces so it can be printed flat, the controller holder snaps into the hole and is rotatable, it's a little tight but it will fit and I didn't want it to freely rotate.
There is a 2nd version of the cover without the logo and the controller hole moved to the center, in case you would prefer that one.
Update 5/27/18, v2 of the controller holder added with the "snap" rotated 90 degrees for printing without support.
Update 7/21/18, Split design for printing on beds around 100mm square. 2 versions, 1 that is just a straight split down the middle and 1 with an overlap to allow more gluing surface, but it's 96mm long so very close to the edges on smaller printers.
Update 10/17/18, Added v3 of controller holder with a center ridge that holds the controller in place.
Update 12/25/18, Merry Christmas! New version uploaded by request with no hole for the controller holder.