LED1

...led1 by pachek thingiverse bulb reference is ikea ledare e27 (or any other led e27 bulb with not much heat release)

...light bulb e27 grabcad light bulb e27

...led bulb e27 grabcad led bulb e27

...lamp grabcad e27 light bulb e27 socket bulb

...e27 light bulbs grabcad two e27 light bulbs: edison bulb (led) and t-bulb (incandescent)

...bulb e27 rustika grabcad this is a e27 bulb with an old school style.

...porcelain socket bulb e27 grabcad porcelain socket bulb e27

...light bulb led e27 cg trader this is an ordinary led light bulb e27.

...e27 base led grabcad e27 led bulb

...e27 holder by jamiematt thingiverse holder for e27 bulb. https://www.instructables.com/id/repurpose-oldblown-light-bulbs/

...led1 by pachek thingiverse bulb reference is ikea ledare e27 (or any other led e27 bulb with not much heat release)

...void loop() { //h digitalwrite(led1,high); digitalwrite(led2,high); digitalwrite(led3,high); digitalwrite(led4,high);digitalwrite(led5,high); delay(t); digitalwrite(led1low); digitalwrite(led2,low); digitalwrite(led3,high); digitalwrite(led4,low); digitalwrite(led5,low); delay(t); digitalwrite(led1,low); digitalwrite(led2,low); digitalwrite(led3,high); digitalwrite(led4,low);...

...and after lights are turned on // with motion digitalwrite(led1low); digitalwrite(led2,low); serial.println("light"); serial.print(lightvalue); // if it is dark then...

...start = 100; start > 0 ; start--) { analogwrite(led1 start); delay(10); analogwrite(led2, start); analogwrite(led3, start); } } void...

...included for customization space for two 5mm leds - led1 = power led2 = onstep guiding...

...infill, no supports. rotate in your slicer part called led1 to face the buildplate with it`s flat...

...ad595cq c1: capacitor 104 (100nf) r1: resistor 330 ohm led1 red led j1: 2p 5.08 mm screw fixed terminal...

...d2 1n4733a do41z10 ic1 ad822r so8 ic2 ad822r so8 led1 (chip led 3528 size) connector (3 pin molex connector)...

...to the + on led1, then from ground on led1 go to + on led2, then from ground on...

...are each connected from the cathode to the anode. led1 is soldered from the anode to the plus bus...