Layer fused x301 for 9mm belts Untested by npm1

Last crawled date: 3 years, 4 months ago

Screws haven't been determined, and it hasn't been tested, however, the 14mm(height) pulleys have been factored in the design for the 9mm belts, with XY motor mounts also adjusted to match.
More specifically:
the XY motor mounts have been thickened,
the DDE motor has extra m3 square nuts for stability
Everything else is the same,
ToDo: further changes the XY pulley system.
Bolts needed:
27mm for the rear pulley stack mount
50mm for the carriage pulley stack
70mm for rear pulley stack
Full credit goes to the designers.https://www.thingiverse.com/thing:4329631
To be printed in ABS for heat resistance, with infill of 40%, can be printed in petg and PLA where an enclosure isn't of concern.
No orientation for the build plate has been factored in, so you may rotate it to minimize support, a 1mm washer may be need for the pulleys as an additional 1mm has been added for printer tolerances.
More feedback will be provided soon. and please don't hesitate to provide feedback below.
Update 15/08/2020: seperated belt clamp from the dde mount, when printing mirror the belt clamp to get both sides
Update 16/08/2020 added a new rear pulley mounting block, so that adds the corner plates holes as to provide better statibility, the screws for mount the rear pulley to the mounts are 12mm as previously advised, whilst the screw for the mount are 18mm
Update 17/08/2020 follow the naming scheme in this case if you'd like a sensor being the bltouch simply download the set ending in _Sensor as well as the Bltouch mount, you may need shims to help set the sensor at the right height., the rear pulley stack mount has been reworked to be mounted along the aluminium mounting plates