Laser cut Quad Copter frame by roadhog

Last crawled date: 3 years ago

Hi All
here are the parts for a quad copter that I am trying to build.
i cut these out on a laser unit that i got from ----.
It did quite a good job i think.
any how there too big to print on my printer at the moment untill i build a new bigger one.
so iv included both sets of files so you can have a play with them.
if you build this please let me know as ill not get chance to work on
this now until the summer,
Hi There
Nothing really special i got of eBay
this is the spec.
220V CO2 Laser 600x400mm USB Port Engraving Machine Engraver Cutting UK Stock
220V-CO2-Laser-600x400mm-USB-Port-Engraving-Machine-Engraver-Cutting-UK-Stock
Application industry:
This machine is suitable to seal engraving, advertisement, art gift, garment, leather, computerized embroidery, packing and printing, paper product, garments sampling, craftwork, woodcut and other non-glass non-metal industries.
Suitable for various materials: Leather, fabric, wool, fur, acrylic, wood products, plastics, rubber, tile, crystal, jade, bamboo products, granite, marble, epoxy resin and other non-metallic products.
Specification:
Reinforced and thickened steel machine body
Built heat dispersed fan to reduce all electronic component’s temperature
Air compressor assistance
Come with support levers, and easy to move the machine
Laser type: Hermetic CO2 glass tube
Working area: 600x400mm (23.6x15.7 inch)
Engraving speed: 0-30000mm/min
Cutting speed:0-3600mm/min
Resolution ratio: 1000dpi
Cooling way: water cooling and protection system
Transfer interface: USB 2.0
Carving depth:0-10mm(depending on different materials)
Software supported: CorelDRAW and WinsealXP
Minimum shaping: character 2mm, letter 1mm
Voltage: AC220V/50HZ
Total wattage: <300W
Temperature: 5-45℃
Humidity:5%-95%
Product dimension approx:102x67x70cm
Platform: honey comb/lifting platform (lift range of 30cm,can adjust)
The machine comes with accessories:
1x 50W water pump (Hmax:3M, Qmax: 2600L/H)
1x 35W air pump (air pressure:0.03MPa, air flow: 40L/min)
1x stand/car kit
Software CD, Dongle, Data cable, Power cord, Smoke pipe.
its not a bad machine ive used it to make a couple of things now like foam board RC model plains, fishing tackle boxes etc.
Its Quite hard to use until you get use to the software.
you can end up wasting a lot of stuff at first but with time and patents some good results
if i was to buy it again i would go for one that as the color recognition that allows you to set the wattage to the color of the cut line, this will allow you to engrave cut and score at the same time.
Hope This Helps
Have a nice day jim