Laptop Stand - Thicker by aero253

Last crawled date: 3 years, 4 months ago

Embellished on the original design from vor4oon to fit an older, thicker laptop. My design incorporates the use of 8mm diameter x 2mm thick magnets that are embedded in it.
To insert the magnets and allow the printer to keep printing over them, just use your slicer to pause the print right before it starts printing the layer that covers the magnets (for me it was at 2.5mm and 21.5mm).
This print works best if you use the line pattern over the magnets (top/bottom layers), other methods ended up not adhering to them very well.