Korg Volca stand for 10x10cm printer beds by Dave1965

Last crawled date: 3 years, 4 months ago

I wanted a stand for my Korg Volca. Found what I wanted on Thingiverse, but it was too big for my printer.
This version is designed to print within a 10x10cm printer bed. Each side of the stand is in two halves, and designed to be bolted together with two small nuts and bolts each (ie: four in total).
Once the two sides of the stand are assembled, they are then linked using three threaded bars. I used 150mm M6 bars with nuts to suit, as shown in the photos.
After bolting together, I added some self-adhesive felt pads (also shown in the photos).
As usual, I take no responsibility for anything: Damage, injury or death. If you can think of it, I'm not responsible for it.