Jack'O Lantern rev 3 by cerberus333

Last crawled date: 3 years ago

This latest version was to address the following.
less angular, more like a real pumpkin <
print without supports<
I printed at the following settings
300 micron slice
scaled at 75mm high (the default of the stl)
2 shells (aka perimeters)
5% infill (to ensure the lid has internal support)
233 °C extruder (ABS)
once printed I use a emery board to buff off the
rough spots on the edge of the lid and the top of the lantern.
I use a hot acetone vapor polish to shine it up (top and bottom separately!)