itek by fugitive829

...rat door holder by itek thingiverse height: 16,3mm - 25,5mm (0.65in - 1in)

...ropeller to achieve some primitive thrust vectoring. i tried to copy the original model as best as i could, and then modified it.

...glue mixer / shovel by itek thingiverse i use this to mix and apply my epoxy two component glue.

...now flake by itek thingiverse snow flake in different sizes: 50mm diameter 80mm diameter 120mm diameter with holes for a wire.

...control horn, 20mm 5 holes by itek thingiverse servo horn, made with 3d printing in mind. perfect for foam rc plane models.

...tek thingiverse water bottle holder. i use it myself, works well ! see drawing for dimensions on the water bottle that will fit.

... 10 screwdrivers. i hotglued mine under the lid of my tool box. i think it will stick. printing with support might be neccessary.

...down to 110mm diameter and a 5.25mm centre hole. increased number of blades to 4. changed from a cw propeller to a ccw propeller.

... 3mm bolts and nuts. you still need a balance shaft and some magnets. inside distance between towers: 135mm inside height: 75mm

...eeds into. press from the bottom to easily press out all dirt when the plant need to be replanted into a bigger pot. good luck :)

...pelican by fugitive829 thingiverse pelican

...snowflake by fugitive829 thingiverse snowflake

...xb by fugitive829 thingiverse this is my first try at a design. hoping to make an ornament for my nephew

...bryan thing by fugitive829 thingiverse this is a thing i made for a friend

...chevron coasters by fugitive829 thingiverse this is a set of coasters pretty simple

...snowflake by fugitive829 thingiverse this is my first upload. i'm trying to make some snowflakes for a laser cutter.

...snowflake set by fugitive829 thingiverse let's see if this works

...rochester new york coasters by fugitive829 thingiverse coasters

...ow. wish me luck. once i figure out the holder i will upload the files. cheers https://www.pinterest.com/pin/407435097526961826/

...rat door holder by itek thingiverse height: 16,3mm - 25,5mm (0.65in - 1in)

...now flake by itek thingiverse snow flake in different sizes: 50mm diameter 80mm diameter 120mm diameter with holes for a wire.

... 3mm bolts and nuts. you still need a balance shaft and some magnets. inside distance between towers: 135mm inside height: 75mm

...glue mixer / shovel by itek thingiverse i use this to mix and apply my epoxy two component glue.

... 10 screwdrivers. i hotglued mine under the lid of my tool box. i think it will stick. printing with support might be neccessary.

...tek thingiverse water bottle holder. i use it myself, works well ! see drawing for dimensions on the water bottle that will fit.

...eeds into. press from the bottom to easily press out all dirt when the plant need to be replanted into a bigger pot. good luck :)

...control horn, 20mm 5 holes by itek thingiverse servo horn, made with 3d printing in mind. perfect for foam rc plane models.

...ropeller to achieve some primitive thrust vectoring. i tried to copy the original model as best as i could, and then modified it.