Inmoov ServoBed V6 and Tensioner Modded by Mindless

Last crawled date: 3 years ago

Servo Bed and Tensioner for "Inmoov" Forearms v6 -Modded-
This Mod involved removing the Open-Air print zones where it was printing with nothing under it
this occurred mainly in the Servo bolt hole positions-
The Tension Bed has been re-worked into one piece with the “Front Cable Mount”
there is a two piece version too,,
There is no change to the overall design, or Servo bolt positions in fact without looking closely you
would think it’s the same as the original, its just had a lot of Panel Beating done to it,,it’s just a clean print now with no clean up required, it was a bit of a challenge to get it to print cleanly-
x3- Bolt/Screw holes have been added to the Tension Bed and Main Servo Bed for easy install,
All Servos are mounted using - 6gauge/ Half-Inch/ Pan-Head/Self-Tapping Screws- which are a
perfect fit for the servos- Remember to heat the Screws before Tapping in,,
the bolt holes are 12mm or half-inch Deep
SketchUp Files are included
Many Thanks to “Mr Gael”
*Note- I use Square M3 Nuts on 90% of my Objects- these are far better then standard Hex Nut in so many ways for 3D Printing-
-= Mindless=-