Inmoov Neck Ballends by Mindless

Last crawled date: 3 years ago

Quickest Mod I’ve Done,,, this Removes the Ball Ends so they can be Printed Separately or if you have Broking your Ballends you can Print Replacement Ones,,,
Ohh Yeah,,, don’t forget to “Hot Tap” the Screws in or you will properly split them again,, just use a Candle or a Tea light – heat the tip of the screw until you just feel the head staring to burn your finger tip- (See Pic )
The Screw Hole is 2.5mm and the Ball is 12mm Dia -
The Main Plate was a bit Butchers during the Conversion from STL cos of the Hi-Res of the Object but luckily it was only on non- critical areas (rounded edges,),, the good thing is that the errors all match so you wouldn’t no the difference if you didn’t know what you where looking for ––,, I wasn’t going to upload the main plate since Broken Ballends seamed to be problem but what the hell,,, its there if ya need it-
I'm using Alans STL files at the moment (I think) - So if he has the time to do the same mod with the Original file I’ll take this one Down—
Many Thanks to Bob&Alan for uploading there work,,,,
-=Mindless=-
P.S-- Didn't put it as a Re-mix because i'm not sure who work i'm actually remixing,,,