Immortal-T support by KodeOut

Last crawled date: 2 years, 11 months ago

TBS Immortal-T mount for TBS Source One HD frame
I needed a mount for the Rx antenna for the frame I'm using in my first quadcopter.
My main goal was to be able to print it without any supports, that's why it's more on the flat side than many other models.
The part is printed upside down.
To print it, just clone the part and mirror it in the slicer.
I'm still thinking about how to improve the design without supports :
the hole for the zip-tie needs to be a bit larger
the ring that goes around the spacer could probably be a bit thinner
I must fin a way to make the open ring "lower" without supports
The "V2" file put the antenna quite a bit lower but probably need supports, I didn't try this version yet since I'll first be using my "V1".