HyperCube Evolution - TW HEVO - Linear Rail Edition by otaku521

Last crawled date: 3 years, 1 month ago

A Remix of sschueller 's Linear Rail System ( https://www.thingiverse.com/thing:2839395 ) using:
2 x MGN12H for Y Gantry
1 x MGN15H for X Gantry
Remix it to use direct drive and M3 nuts and bolts instead of Brass Inserts and Dowel Pins
1) The motor box sits on TOP of the MGN15H and X carriages -
a) it sits 15 mm over the edge for clearance for bond-tech BMG direct drive/titan extruders + V6 with Volcano (with 30mm fans) -
b) estimate can install the 30mm fan + 5015 fan shroud be fine.
c) Using Percision Piezo hot end mount (which increased 20mm)
d) Volcano Heater Blocks is required (which increase 8mm Height from V6 normal) for height clearance
This means that it should have enough height clearance for the direct drive extruder to work out (note I used a 10mm thick Glass Bed!!
2) the plate is used for keeping it in squared otherwise it is used for further development of bowden systems or other uses
3) it should be very close to the top edge of the normal HEVO build for your leadscrews