hera reworked grip and stock by CravenPayne

Last crawled date: 3 years ago

!!!UPDATE!!
!!BIG UPDATE!!
removed the original front part stock and grip to a better supported so the print wont get distorted at all 100% print at all time just break the cylinder of after the print has cooled down and set properly and trim of the extra material hope everyone gets awesome prints and i'm glad that people like my reworked designs and added a longer sniper stock model with pieces to fit longer and shorter persons
added a new gcode and stl to the front pice i noticed it wouldent generate support propperly when printed ;/ but its fixed now it only adds 20 min print time to :)
2 update hera stock sniper mod added new segments so you can make the stock fit people with shorter or longer arms
iv taken koobysnacks77's hera stock and reworked it so it will fit most aeg air soft ar15 style rifles
front grip:added more grip area for the rail mount and made it ambidextrous so the thumb rest is on both right and left side and added a third screw hole
Stock: beaver tail widen and reduced to fit most aeg's without modification or sanding
mid section on stock lengthened for larger battery's motor plate slimmed down a bit to fit better
added some material on the motor grip so its more robust so it will need some sanding depending on motor seize and p.s sorry for my bad English he he
This is the Hera CQR stock for M-4/AR-15 pattern AEG airsoft rifles. The design is not 100% the same as the real-steel version as the pistol grip has to house the motor. The measurements for the interface are from the lancer tactical LT-12, this may not fit your gun exactly, however, it should fit most.
ASSEMBLY:
-Remove the stock, motor, and pistol grip from your current gun. Set aside the screws used to secure the pistol grip to the gearbox, as well as the endcap/radiator for the motor, these will be used later.
-Slide the stock onto your gun's buffer tube, before it is slid completely on, route the motor wires through the holes in the grip-section.
-Once the stock is slid all the way down, use the screw you set aside earlier to affix the grip to the gearbox.
-Next insert the Body retaining pin (or a similarly-sized pin) into the hole near the base of the buffer tube.
-Insert the motor into the motor housing, attach the motor wires, and secure th motor in the housing with the endcap/radiator from the old pistol grip by screwing it into the holes at the bottom of the grip.
-Next slide the motor plate into the channel so that it looks like the pictures above.
-Slide the butt pad into it's registers in the back of the stock.
-Finally, insert 1/8 inch (3.175 mm) pins in to the holes marked with red circles.
instructions provided by koobysnacks77