GoPro Hand Pistol Grip by waddington

Last crawled date: 2 years, 11 months ago

A remix of Kart5a's GoPro Handgrip: https://www.thingiverse.com/thing:1696154
My remix cuts the model in half to make it printable with the layer lines in a more desirable direction for strength of the model, particularly where the camera attaches.
I cut their model in half and add some locating pins for alignment.
Print 1x Left, 1x Right, 3x Pip. The pips should push tightly into the holes on the inside of the grip. Glue them in, then slather glue all over the pips and the flat surface, and press the other half on. Apply some pressure while glue dries (from another 3d printed clamp, or from elastic bands or something). I simply used superglue on PLA+ or PLA and it works fine.
I have some slight elephants footing where the 2 pieces will join, but it is still very comfy in hand, so hats off to Karta5 for a great design.
If your tolerances aren't so good, the holes in each half are 5mm5mm square, 3mm deep. The pip provided is 4.6mm4.6mm*5.4mm. If it doesn't fit it should be easy enough to model one in Tinkercad pretty quickly. They make sure that both halfs are aligned for glueing.