Gloomhaven monster box by lukaszsw

Last crawled date: 3 years, 1 month ago

Summary
A box to hold monster cards, standees and sheet for board game Gloomhaven.
For Unsleeved cards only (takes less space and that is how I store it).
The idea is to speed up the set up and tear down. Instead of searching individually for standees, decks and sheets, they are in one place. You can leave the sheet in the box if you are using stands with life counter.
minimum dimensions, minimum space requirement
Only 102x102 mm, fits on the printbed, uses 15-17 g of filament and prints in 45-54 minutes. Theoretically all boxes should be 163 mm high if stacked on top of each other. In practice, all of my boxes total 180 mm which is
other designs to checkhttps://www.thingiverse.com/thing:2705022 - box for sleeved cards, first design on thingieverse by by Knekkebjoernhttps://www.thingiverse.com/thing:2797796 - box for sleeved cards, ultimate box by YY-Guyshttps://www.thingiverse.com/thing:2507046 - standee base with life counter
https://www.thingiverse.com/thing:2789122 - - dice stand to track XP and HP - my own design :)
Variations
3.7 mm: for monsters with small standees that fit into single layer (inside is 2.5 mm high, minimal for deck height)
5.2 mm for all other monsters.
14.5 mm for boss stadees and all boss sheets
all come in two designs, 'Gloombox2' was easier to print for me and has more space inside
Estimated number of boxes
Gloombox: ? (will update but I've switched to second design - Gloombox2)
Gloombox2: 19 x 3.7 mm, 15 x 5.2 mm. Monsters that go into 3.7 mm box: Bandit Guard, Bandit Archer, City Guard, City Archer, Vermling Shaman, Living Corpse, Living Spirit, Cultist, Giant Viper, Forest Imp, Hound, Cave Bear, Ancient Artillery, Rending Drake, Spitting Drake, Savvas Icestorm, Savvas Lavaflow, Harrower Infester, Deep Terror.
Boss box: fits all bosses in 4 layers.
Design notes
Walls are 2 mm wide because Slic3r will by default creates double perimeters for it, while it was creating a single perimeter (+gap fill) with anything less than 2 mm. Bottom is .5 mm - gets the job done and is ideal for the first two layer heights .32 and .2
Updates
2018-02-24: Added slide-in rail for design 'Gloombox2'. I thought the tolerance by itself would keep the lid in place but after a while some of my boxes became loose. Much better now. Design 'Gloombox' seems ok thought
2018-02-16 #2: Updated number of boxes for the design 'Gloombox2' - 19 thin ones and 15 thicker ones (was 17 and 17)
2018-02-16: Increased boss box thickness to 14.5 mm. As you can see in the photo I was missing two standees and only noticed in the end. Add the first design type box (didn't test if it fits all standees).
2018-02-11: Added .2 mm to both boxes thickness. Added second design 'Gloombox2' - prints better and has more room for standees. Added boss box.