Garmin Edge Vertical Bike Mount by Rubidium

Last crawled date: 3 years ago

This is a vertical bike mount for a Garmin Edge. I created this at the request of my father so that he can mount his GPS on the vertical section of his handlebar, which has a diameter of ~28 mm (apparently all of the other real estate is taken up by other gadgets and gizmos!). In addition to the two parts on this page, you will need two part's from Andiwu's bike mount (see "remixed from" link), some zip ties, a 5M machine screw that is at least 25 mm long, a 5M hex nut, and some glue/epoxy. The parts printed fine without supports, but did require some trimming. Please note, this is version 2 of these parts, which have been tweaked to make the area around the bolt hole more sturdy. These parts have been field tested and work well, but you may need to use some tape or a rubber band between the mount and your bicycle bar so that the mount does not spin around on the bar.