Garbage Container by JanisSB

Last crawled date: 3 years, 3 months ago

Trash container model
A very simple trash container design with a lid, designed specially for a special kid. Model suitable kids (and adults) who like (or are obsessed) with trash containers, garbage trucks e.t.c.
Necessary parts for assembly:
1 x Container (3 design variants available)
1 x Lid (3 design variants available)
2 x Hinge
2 x Hinge_lock
Assembly:
Option A
1.. Insert Hinges from inside of the container in the designed slots and slide them down in the slots as low as possible;
2.. Insert Hinge_locks from the outside and press them into the open slot;
3.. Stretch the Lid legs over the hinges one side at a time, press firmly so the Hinges pass trough Lid legs all the way;
4.. Marvel at Your new model.
Option B
If using hard filament that is not very flexible or is brittle (for example PLA) that makes it hard to stretch the lid legs over the hinges:
1.. Insert one Hinge from inside of the container in the designed slots and DO NOT slide them down in the slots;
2.. Attach Hinge_lock from outside on the Hinge (make sure not to put it in the container slot);
3.. Attach Lid leg, by pressing the hinge trough Lid leg;
4.. Repeat steps 1. trough 3. for other side;
5.. Slide the whole assembly down into the Container slot as far as it will go;
6.. Rotate Hinge_locks so they match the openings and press them into the open slot;
7.. Enjoy.
Available design variants:
Containers (bottom part)
V0 - container design with original owners embossed logo;
V1 - container design with empty frame for custom logo;
V2 - container design without logo.
Lids (upper part)
V0 - plain lid (without openings);
V1 - lid with two circular openings;
V2 - lid with square opening.