FormD T1 DDC bracket for front spine by gertschman

Last crawled date: 3 years, 4 months ago

Hey all,
this is a simple bracket to mount a ddc pump to the front spine of the FormD T1.
It has a little cut out for the cable of the pump. This might be needed if you mount it in the same direction as I did, to not squeeze/damage the cable.
I used tow of the screws that came with the case to mount it to the front spine. It is designed to just screw into the bracket itself, without threads. The slots on the pump side help with the positioning. You'll need two additional screws for this (size tba).
Please make sure that you printer is fully calibrated, or otherwise the bracket might not fit.
Here are some important steps to go through:https://teachingtechyt.github.io/calibration.html#intro
Especially make sure that your hole expansion is set correctly in your slicer.
For instance in cura: https://www.youtube.com/watch?v=UUelLZvDelU&ab_channel=CHEPfusio
I'll add all the measurements later on and might even do a customizable design.
Feel free to ask any questions, and if you feel like it a coffee is highly appreciated! :P