Folger FT-5 Y Endstop Pair by PolyGurl

Last crawled date: 3 years ago

I am using the 713Maker Gantry kit which changes the Y end-stops. This bracket mounts the Y end-stop off the left rear 2020upright. V1 was made out of PLA and last pic showing on the build plate. Trimmed it down for V2 and made from PETG.
Was designed for the optical variety of end stop. But works with the mechanical, just a tad close on the PCB lead cutout. Trim off the flag for mechanical endstops.
Update: Gantry Flag model is complete!. The optical Endstops I purchased required inverting the logic in firmware as they were showing triggered when sensors were unblocked, and open when blocked. Very repeatable positioning. Within one step. :D Happy Dance!
Update: Uploaded end cap version for mechanical end stops. Don't need to clip off the flag and there is a nice wide flat spot for the switch to trigger on.
Gantry End has support built-in for the flag. Place FT5 on the print bed and it will print like a champ! Parts built for 0.4 nozzle. Should slice fine with default extrusion width 0.4mm.