Fixxed size by BluJ

...m8 nut cap closed fixed size to 13.2mm by njozsef thingiverse m8 nut cap closed fixed size to 13.2mm

...cable clamp fix 30x30mm 20x20mm 15x15mm by zhenyaka thingiverse 3 size cable fix for clamp fixing.

...ixed parts by marcel_robert thingiverse remixed to fix the size of holes in the model to fit proper size screws work in progress

...uic thingiverse fixed version of https://www.thingiverse.com/thing:3617447 tested it in cura and it imported to the proper size.

...iphone 6 plus cas need to fix the size by mile_zdr thingiverse download is temporarily down until i fix the size issue's

...stance between the holes and the base fixed the slide entry at rear fixed clip tolerance fixed bolt size this is now usable! huza

...pipboy 3000 fixed scale by bluj thingiverse original was under sized, fixed it so it prints 1:1

...rs with fixing wires by shadow35 thingiverse quad motor skid for 1806 size motors (16 - 12 mm) with groove for fixing esc wires.

...misha's nautilus gears bar fixed by fancy_raptor thingiverse this was made to fix the under sized holes on the bars

.... still too loose. ssd din mount fixed size original model was too big original: https://www.thingiverse.com/thing:3822296/makes

...pipboy 3000 fixed scale by bluj thingiverse original was under sized, fixed it so it prints 1:1

... find a holder for the steam controller so i decided to make one! just print the stand and steam logo separate and glue together.

...on the amazon.com, and wanted to use my mk7 filament driver for it so i made a jhead mount and holder for the 10mm screwy thingy.

...es all together. uses 3 m3 screws to clamp the frame and 1 to hold the camera. if this was helpful to you please drop a comment!

...fix by jmg214 thingiverse fix

...fix by lamerhouse thingiverse fix

...fix by jbelux thingiverse fix dragon and acc

...fix by kpcampbell07 thingiverse fix to schmidt nameplate

...fixes by gorilla_grodd thingiverse some fixes for previous assets

...beyblade fixed thingiverse the original version of this model was broken. this fixes the gap in the middle.

...anchor fix by syzguru11 thingiverse anchor fix

...fix and support by lamerhouse thingiverse fix and support

...fix and support by lamerhouse thingiverse fix and support

...size by hish thingiverse check size validation

...new size scraper thingiverse size change

...e table to finde the right size in your country. just type in the id (inner diameter) in mm and with a point (.) not a comma (,).

...ogryn sized shotgun thingiverse ogryn sized shotgun

...from a necklace! if you would like to purchase a physical print of this model visit my shop on shapeways @ http://shpws.me/nlsu

...re-sized box to credit card size by bacad thingiverse resized the box to make it fit credit cards.

...multiple sized pots by gladdis20210213 thingiverse they come in a variety of sizes. lots. of. sizes.

...in to fit in a hole. i used a "paint marker" with the point on its side to mark the increments over the embedded sizes.

...7.9 axis short - 5.8 circumference - 21.7 hat size - 6-7/8 head-2 axis long - 8.1 axis short...