Filament Halterung P3 Steel by Grinch74

Last crawled date: 3 years, 1 month ago

I always hate the normal supports for the Filament rolls on the tabel.. So I construct in 2 min this little arm that keeps the Roll in position. This ist for a 2.1 Frame of the P3 Steel. But u only need a little hole 2 fix this arm.
The hole in the arm has 55mm dimension, so a tube with 53mm dimension will fit quite well. U dont need any bearings.
Cause SolidWorks has an easy way 2 draw the threads, I added some M12 threads into the part. But u have 2 trim those Threads after the Printing a little bit for easy use.
U need for the fixation a Bolt M12x20 or 30. I use a DIN7991 M12x20 Countersunk Bolt. Therefore i made a litte plate where it can sit in.
The Bolt on the Top of the Arm is just for the case u use Filament Rolls with a smaller hole.
The maximum high of the Arm is about 195mm. So Check if u can print it.
The Tube for holding the Roll is 150mm long . U can make it longer if u like.
Just draw a tube with 53mm outer perimeter and maybe 3mm wall. This should be enough 2 hold anything ;-).
added a fixation for a table with 18mm gap. works fine for me 2