Extruder wire brace for Kodama Trinus by Singular

Last crawled date: 3 years ago

Can be used for anything really but it was designed to fit snuggly over the extruder head cables for the Kodama Trinus after wrapping it in electrical tape.
The inner diameter of the round section is 9.3 mm. The base comes together and leaves you approximately 2 mm to put your wires through. I added a filet to most edges to help reduce stress on the wires.
I used 3m double sided weather proof sticky tape (the grey stuff). This stuff is amazing and although it says it is permanent I have removed it several times without damage.
The orientation of the print adds a lot of strength to the bracket so depending on material used you can get a bit of flex to it to expand it a tiny amount.