Ender 5 (Pro) 4020 Fan Shroud with BLTouch/3DTouch mount by Bounc3D

Last crawled date: 3 years, 3 months ago

I added an "adjustable BL-Touch mount" onto the fan shroud so it will fit on an Ender 5. I moved it 10mm to the front to clear the belt clip.
I closed up the underside a bit and adjusted the air exhaust on the side.
The offset i measured is: X: -44 and Y: -24, please doublecheck your own offset!
Use the adjustable BL-Touch mount as shown in the original fan shroud.https://www.thingiverse.com/thing:3383198
The fan shroud needs supports to print, i used tree-supports in Cura. I placed the back side of the fan shroud onto the printbed. It looks nicer when printed that way.
There is just enough room in front of the fan shroud to not make it crash into the frame. Please check your own settings and possible attachments to the frame which might cause problems.
You'll need longer m3 bolts than the standard ones for the fan shroud: M3x16 (x2). Then you'll need some more M3 nuts and bolts to fix the bl-touch.
ps.
The cap on the bl-touch is this Thing:http://www.thingiverse.com/thing:3419174