Ender 3 Front Drawer by DanielPdaSilva

Last crawled date: 3 years ago

I was looking for a robust front drawer for my Creality Ender 3 and saw a cool design for the Ender 3 Pro: https://www.thingiverse.com/thing:3162464.
I decided to make a remix of that part and tried to print it with the dimensions for the Ender 3. However, I didn’t like very much the result because of the support marks.
Then I came up with a solution that doesn’t require any supports, by dividing the geometry into 2: main body and flap. I applied a little bit of tolerancing to guarantee the fit and to get the correct diameters of the holes for the screws.
I chose to use 2 M3x8 Pan Head Cross Screws. In the current design, the maximum length of the holes in the main body is a bit higher, thus M3x10 should fit as well…
Notice the following aspects:
• The current dimensions of this model have in consideration the cable clips mounted, on the Printer, behind the drawer!
• Follow the assembly procedure below!
Assembly procedure:
Unscrew and detach the screen module;
Mount the main body (“Part1”) of the drawer (it is necessary to give it a little push);
Once the lateral flap of the main body is contained in the profile where the screen module is mounted: Pick the flap part of the model (“Part2”) and align it with the 20x40 profile slot;
Align the holes and screw the parts together.
Once that is done, only reassemble your screen module and you’re good to go for the next print or upgrade! ;)