ECX Temper GEN2 axle servo battery tray by GRay_111111

Last crawled date: 3 years, 4 months ago

PLA is fine, increase wall thickness, and 1mm top/bottom. at least 50% infill works nice.
Servo tray for the ECX Temper Gen2
You will need:
M2 x 20mm bolt (and maybe a few M2 washers space) - for the ends of the tray - these replace the M2 x6mm bolts in the axle ends (C knuckle) - check the length, is needed a couple of washers will space out the bolt if its a tad too long.
M4 countersunk bolt (8mm long) - for the servo brack in the centre, stock bolt fouls the axle moulding)
Possibly need to shorten the servo link rod - 3mm threaded rod cut to length works great.
You can also run Over The Axle steering link whilst doing this mod - use 3mm threaded rod, bend to shape to fit over the axle and sit below this tray between the axle stand offs.