E3D Chimera/Cyclops mount for Rostock MAX by 626Pilot

Last crawled date: 3 years ago

This is for mounting a Chimera/Cyclops hot end under the effector. It's compatible with my LED snap ring and other accessories, EXCEPT for the blower ducts. You will need something small, like some pliers or an Allen wrench to release the Bowden tubes.
My blower duct doesn't work with these hot ends because the height is different. I have a dev version, but the exhausts are too close to the hot end so I need to redesign them a little. The fix will be in later this week.
Use the three screws supplied with the hot end, and make sure your fan is hot-wired - that's it!
Changelog
4-22-15: Enlarged the access holes for the Bowden feeders a little, redesigned the cable management (removed one wire clip and took the tang out of the other), and added some stiffening strakes to the top surface.