Dremel 3D40 / 3D45 Rear Filament Holder by Waggster

Last crawled date: 3 years, 1 month ago

A very simple removable filament holder for the rear of the 3D40 / 3D45 Idea Builder Dremel 3D Printer.
I used a 4mm drill for the four holes required. The filament bracket was first secured on then I ran the drill through the 45-degree tube hole to make sure I got the right position and angle.
You will also need around 200mm of 4mm tube for the filament and also 3 M3x15mm (ish) screws with washers and nyloc nuts.
TIP - I left the printer turned on and turned the lights down in the room I was in. This made it easy to drill from the outside as you could see the ribs in the plastic from the back.
Hope it comes in handy, let me know if it's useful or if you need any changes etc..