Dragonlink SLIM JR Holder + Ground Station

Last crawled date: 4 years, 3 months ago

:EDIT 25.11.2019
JR Holder reduced to 45 mm width, so that the Dragonlink module better clicks on the holder.
Small changes to the Backcover.stl and Bottom.stl due to the change in the width of the JR slot
:EDIT 21.11.2019
Added second holder for a tripod
Switch removed from the "Backcover.stl"
:EDIT 19.11.2019
2 small errors in the "DL Module Holder" repaired.
a small change in the "Backcover.stl"
:EDIT 16.11.2019
Front cut slightly adjusted and edges rounded.
Side opening for better cooling
Reduces the JR bay hook to 10mm to better fit into other modules.
I have adapted my JR holder for the SLIM version of the Dragonlink.
Here is the version for the big Draonlink transmitter (V3 Advanced)https://www.thingiverse.com/thing:3962364
This holder fits into any FrSky remote or with my holder, which can be used as a separate relay station in conjunction with an extra receiver(i use an FrSky X4R)
Inside are 6 LiIon 18650 (3S2P) cells installed - so you can really "long rangen".
In the holder is enough space for additional accessories, which everyone needs or wants to use.
Down behind the Dragonlink module is a small shaft where the cables can be routed backwards. (marked red in the picture)
But I have to say that I have not yet printed this JR-holder, because I have no SLIM module and have adapted it only based on existing templates to my ground station.
That's why I marked it as "work in progress"
PARTLIST:
6x 18650 LiIonBANGGOOD
JST-XH 3S LiPo Balance Cable:BANGGOOD
1x Battery Indicator Display Board:BANGGOOD
1x XT60 Plug:BANGGOOD
1x 3S Balancer Plug:BANGGOOD
1x Switch:BANGGOOD
1x Pins: (5x male and 5x female)BANGGOOD
1x Switch (Optionally to switch the DL module on / off separately)BANGGOOD
1x Batterie Kontakt:EBAY