Double monitor adjustable wall mount by davidpp99

Last crawled date: 3 years, 4 months ago

This is a double monitor wall mount with adjustable horizontal position, tilt and rotation. The objective was to keep the monitors as close to the wall as possible while having some adjustment.
It uses VESA 75x75mm
To adjust horizontal position you can just slide the rail. To adjust tilt, loosen the top bolt on the tilt adjustment part, set your desired angle and tighten. Rotation of the monitor can be done by hand with no force required.
Tilt range is -10 to 20 degrees
Rotation range is -15 to 15 degrees for a 22 inch monitor.
There is a 5 fixed positions for tilt version and a free tilt adjustment for the rail mount.
Rail mount must be mounted before hanging the rail to the wall.
Tip: Reuse the support for the wall mount screw holes to cover the screws later on.
IMPORTANT: Weight of the monitor should not exceed 3kg. While printing the monitor mount layer adhesion is very important, test your print before assembly. Also check that the back of the monitor doesn't get too hot to affect the material strenght.
Materials:
1 M8 x 45mm for rotation adjustment
2 M6 x 50mm for tilt adjustment
2 M6 Nuts
4 M4 x 12mm for vesa mount
24*24mm square aluminium tube (as long as you need, I used a 75cm one)
Washers
4 Screws to fix the setup to the wall
Printing:
I recommend using PETG.
Infill:
50% Infill: Parts 1 and 2
75 ~ 100 % Infill: Parts 3 and 4
Layer height:
0.28 Parts 1 and 2
0.2 Part 3
If posible adaptive layers to get the details in the top part where the shaft goes and print the base part faster. If not possible use 0.16
Line count: 4 (minimum)
Supports: yes all parts. Everywhere.